13" Braided stainless steel hose.
Direct Replacement that fits both Automag and Minimag Stainless Valve Bodies.
Sear Assembly includes everything you see here. Fits Automag, Minimag and Classic rails. Does NOT fit the Tac rail, which needs the RT Pro Sear Assembly.
The sear has this special hardened steel axle that it rotates on. For Automags, Minimags and Classics, unless using the Tac rail - then the Emag/RT/RT Pro Sear Axle Pin is required.
About the only thing you really have to replace in the Mag is the O-rings, so we batched them all together in this handy kit. A must-have for the serious Mag owner!
Classic Back Bottle Bolt. Holds the original back bottle adaptor to the rail assembly.
Classic Barrel Oring for twist lock, bayonet mount barrels. Also used with part #000845 Regulator Nut Assembly as the tension o-ring.
Minimag Barrel for both hopper left and hopper right powerfeeds. Clear anodized finish.
Original 11" RT Barrel with Ported Stainless Tip - fits any of our steel powerfeed mainbodies.
Twist lock assembly that holds the barrel in place. Needs to be pressed in and out.
Compatible with X-Frame / Intelliframe style grip frames. Available in black or silver.
Bolts from AGD are made from hardened stainless for extra long life. This is the foamie style.
Bolts from AGD are made from hardened stainless for extra long life. This one is the Foamieless Style.
The Bolt Spring fits all AGD markers regardless of age or type. They are made from very special square wire so they don't fold inside themselves when collapsed. Replace your old springs when they sag below the front of the bolt.
1/8 inch NPT output mounts to the bottom of AGD grip frames.Black anodized finish.
This is a urethane washer that sits at the base of the power tube. When the bolt returns, it hits this to decelerate.Now sold in packs of 2.
Holds washer in place in all our Aluminum MainBodies
For use only with The Classic Automag RT ONLY . Rail comes blank. No parts included. Picture shows 1/8 plugs and barrel lock. These items are NOT included. Available in black only.
Screws in the side of the marker into the sear bushing.
The stock RT ULE feedneck.
Completely assembled banjo bolt for your RT.
The Field Strip Screw holds your valve in place. Also fastens the Emag battery to the frame.
Prevents Field Strip Screws from loosening. Fits all guns except the Automag RT. Sold in packs of 2.
Rubber foamies go easy on paint! These are replacements for the foamie bolt. Glue them in with superglue and let dry overnight.Pack of 4.
10-32 button-head cap screw that holds the front of the gripframe to an Automag or Minimag mainbody. This is the shorter screw for AM/MM only.
Choose dust or gloss. When available.AGD/Angel threaded.
For the Intelliframe.4 pieces as shown.
The Level 10 Low Impact Superbolt Kit reduces paint chopping. This is not a "drop-in and shoot" part - you'll need to tune it according to the enclosed instructions.
The Retro Valve uses two coil springs behind the Regulator Piston. This is the larger of the two. Should never need replacing - just keep it greased.
The Regulator Seat O-ring is the business end of the regulator. Replace if you are having problems with velocity.Sold in packs of 4.